Transmitter connection

As per Chris' request, I made some pictures of how the transmitter could be connected.

First, your solder some wires between the important pins as shown in this picture:



The pins are (counting from the bottom:)
Pin1: GND (black wire)
Pin2: +5V (red wire)
Pin6: RA2 (green wire)
Pin13: RA4 (yellow wire)

The wires can be a bit shorter probably. Just see what fits nicely for the box, keeping in mind that it shouldn't be awkward to open the box in case of need.

then, connect one side to the transmitter:





and the other to the CUI board:



and voilà:



P.S.
interesting, as I was writing this and looking at the pictures again, I realised I had wired the green wire wrong... so I needed to make the pictures again...



undefined